Subject	I used carbide bits.
Posted by	Sum0n3 on April 16, 2010 at 12:03 AM
	This message has been viewed 89 times.
In Reply To	Nice!.. What did you use to do the port work? posted by KongZTT GT28RS MD on April 15, 2010 at 06:05 PM
Message	Mainly the coarse ones for aluminum to start removing material. Then switched to the finer set that's meant for steel, as it does an excellent job smoothing out. All done with a air die grinder. For finishing I used a dremel sand paper flap wheels, and good old sand paper and finger for polishing. As for the AN fittings.. They're actual AN fitting that need the tube to be flared for installation. I got them from Summit Racing.
Follow Ups	My project so far.. - Sum0n3 04:32:42 04/15/10 Very Nice (n/m) - toykoz32 04:40:37 04/15/10 I tried to keep the budget in check.. - Sum0n3 12:58:36 04/15/10 sweet, someday I hope I have the know-how and experience - LJZTT 05:01:30 04/15/10 Thanks! - Sum0n3 05:06:31 04/15/10 smooth. looks like fun. (n/m) - eazyez 05:25:41 04/15/10 Very nice. - Boosted1 06:03:18 04/15/10 looks great!! im always paranoid about putting main studs in - fst300zx 06:07:26 04/15/10 Yooooo....whatup luke! When you opening back up? (n/m) - ZiNnYc 06:23:10 04/15/10 Looking Sharp! (n/m) - Ash's Z 07:51:09 04/15/10 You should benefit a lot from that port work. (n/m) - Turnerscasa (Dallas) 08:00:35 04/15/10 i like it!! (n/m) - 1badz32 (MN) 08:08:39 04/15/10 Looks great! - zfreak(Dallas) 09:50:18 04/15/10 Nice work!! (n/m) - Josef(Houston) 10:49:31 04/15/10 Fantastic. I wish I had the space for this - there is - 300NASeattle 12:05:26 04/15/10 I tried to keep the budget in check - Sum0n3 13:00:48 04/15/10 cool...well I needed it on the lift to check the - ZiNnYc 14:41:02 04/15/10 Nice!.. What did you use to do the port work? - KongZTT GT28RS MD 18:05:11 04/15/10 I used carbide bits. - Sum0n3 00:03:05 04/16/10 nice.. Looks like you've done some great work! (n/m) - KongZTT GT28RS MD 15:26:23 04/16/10 Thanks for sharing all this! (n/m) - BoneZ 20:26:17 04/15/10 looks great! I applaud you for such an endevour.... - Ghozt 22:12:26 04/15/10 Thanks for the interest guys! (n/m) - Sum0n3 00:04:28 04/16/10 Nice work! (n/m) - Turbodog (CT) 07:03:18 04/16/10 Looking good. (n/m) - Cuis-Z 09:08:01 04/16/10 Those are some clean internals. Quite lovely. (n/m) - schuss 12:29:32 04/16/10
Post a Followup	You cannot reply to this message because you are not logged in.