Subject	I didn't bend or weld the cage... it is my design
Posted by	TURBOGAGE(MATTZ Garage) on April 15, 2010 at 3:11 PM
	This message has been viewed 107 times.
In Reply To	Matt did a good job he showed me it after it was welded in (n/m) posted by Z32TT-R on April 11, 2010 at 03:47 AM
Message	and was coordinated with NASA racing rep to make sure it was legal and is good through time attack trials. overall, very happy with how it all came out. thanks Ken for all your support and good words. Best run: 1.60 60', 11.319 @ 120.65 mph - 118 octane fuel (on 100 octane tune), 22 degrees of timing, 21-22 psi boost, 11 psi tire pressure (street slicks). "..know your car better... RACE IT!.. AS OFTEN AS POSSIBLE.." "Drag racing is for fast cars... Autocross is for fast drivers... Drifting is for cheap tires..." I made up the last one..
Follow Ups	WinFactory Roll Cage - ken060984 20:39:34 04/09/10 Looks good! How much was the roll cage? (n/m) - ForceFedTT (SoCal) 21:42:10 04/09/10 2nd! Looks really nice. - pearlwhite94ttz 22:43:02 04/09/10 thanx. i forgot how much it cost after everything, since i - ken060984 00:57:10 04/10/10 Very nice. You've got a nice setup there. (n/m) - Milo (SATX) 21:52:20 04/09/10 Possibly full of WIN - Drk93TT 22:07:27 04/09/10 Looks Great, fitment is pretty tight! - StaticZ32 03:48:56 04/10/10 Glad to see the car up Ken - jspeckid 05:19:04 04/10/10 Re: WinFactory Roll Cage - knerona 12:20:03 04/10/10 Very nice. I always thought the Low Max - Boosted1 12:47:53 04/10/10 yes, PLENTY of clearance for my helmet. and that's with the - ken060984 21:32:59 04/10/10 Wow, exactly what I want to do... - Fake_Blood 13:42:23 04/10/10 On a side note...what nose panel is that? (n/m) - scottyfender 17:03:29 04/10/10 that is an abflug panel. haven't seen anybody else with it - ken060984 21:35:32 04/10/10 Matt did a good job he showed me it after it was welded in (n/m) - Z32TT-R 03:47:59 04/11/10 I didn't bend or weld the cage... it is my design - TURBOGAGE(MATTZ Garage) 15:11:26 04/15/10
Post a Followup	You cannot reply to this message because you are not logged in.