Subject	Very nice.
Posted by	Boosted1 on April 15, 2010 at 6:03 AM
	This message has been viewed 74 times.
In Reply To	My project so far.. posted by Sum0n3 on April 15, 2010 at 04:32 AM
Message	Not sure about the Exh manifolds though. With all the effort you have put in, even ported stock is no comparison to Mike Smith Manifolds.
Follow Ups	My project so far.. - Sum0n3 04:32:42 04/15/10 Very Nice (n/m) - toykoz32 04:40:37 04/15/10 I tried to keep the budget in check.. - Sum0n3 12:58:36 04/15/10 sweet, someday I hope I have the know-how and experience - LJZTT 05:01:30 04/15/10 Thanks! - Sum0n3 05:06:31 04/15/10 smooth. looks like fun. (n/m) - eazyez 05:25:41 04/15/10 Very nice. - Boosted1 06:03:18 04/15/10 looks great!! im always paranoid about putting main studs in - fst300zx 06:07:26 04/15/10 Yooooo....whatup luke! When you opening back up? (n/m) - ZiNnYc 06:23:10 04/15/10 Looking Sharp! (n/m) - Ash's Z 07:51:09 04/15/10 You should benefit a lot from that port work. (n/m) - Turnerscasa (Dallas) 08:00:35 04/15/10 i like it!! (n/m) - 1badz32 (MN) 08:08:39 04/15/10 Looks great! - zfreak(Dallas) 09:50:18 04/15/10 Nice work!! (n/m) - Josef(Houston) 10:49:31 04/15/10 Fantastic. I wish I had the space for this - there is - 300NASeattle 12:05:26 04/15/10 I tried to keep the budget in check - Sum0n3 13:00:48 04/15/10 cool...well I needed it on the lift to check the - ZiNnYc 14:41:02 04/15/10 Nice!.. What did you use to do the port work? - KongZTT GT28RS MD 18:05:11 04/15/10 I used carbide bits. - Sum0n3 00:03:05 04/16/10 nice.. Looks like you've done some great work! (n/m) - KongZTT GT28RS MD 15:26:23 04/16/10 Thanks for sharing all this! (n/m) - BoneZ 20:26:17 04/15/10 looks great! I applaud you for such an endevour.... - Ghozt 22:12:26 04/15/10 Thanks for the interest guys! (n/m) - Sum0n3 00:04:28 04/16/10 Nice work! (n/m) - Turbodog (CT) 07:03:18 04/16/10 Looking good. (n/m) - Cuis-Z 09:08:01 04/16/10 Those are some clean internals. Quite lovely. (n/m) - schuss 12:29:32 04/16/10
Post a Followup	You cannot reply to this message because you are not logged in.