Subject	have the hub run-out measured no matter how you do it
Posted by	KasbeKZ(VA) on April 06, 2010 at 10:39 PM
	This message has been viewed 63 times.
In Reply To	to buy new rotors or have them machined... posted by edharken on April 06, 2010 at 07:14 PM
Message	it doesn't matter what you do to your rotors, if your hubs have run-out, they will warp pre-maturely. as an extreme example, i had mine turned and they were warped to their previous state again 3 stops into the break-in procedure. i now have new hubs AND new rotors. a good example, but these were the '90 26mm rotors and they had been turned off the car, so it would certainly not be quite that bad for you.
Follow Ups	to buy new rotors or have them machined... - edharken 19:14:29 04/06/10 I took mine off and had them turned for ~$10 each - Agent X 19:53:37 04/06/10 I think you're supposed to turn them ON the car. (n/m) - SimaYi 20:33:10 04/06/10 How does that work? (n/m) - ShakaShaun(Denver) 21:14:37 04/06/10 machine - JRFITZ 21:46:02 04/06/10 I can't find the original link I saw it under... - SimaYi 22:42:16 04/06/10 according to nissan you are right... - Antihero 09:53:04 04/07/10 Re: to buy new rotors or have them machined... - jrsavinon 19:57:09 04/06/10 Re: to buy new rotors or have them machined... - Ketshy 20:28:31 04/06/10 have the hub run-out measured no matter how you do it - KasbeKZ(VA) 22:39:33 04/06/10 Cheaper on ebay - idrivefast 23:32:12 04/06/10 it's a close race between brakes and fuel components as to - LJZTT 01:44:33 04/07/10 Or you can always drive fast into a wall or another car? - 5280Z_nightstalker 02:09:56 04/07/10 in the light of all the hubub in the US over toyota regardin - LJZTT 05:02:38 04/07/10 Oh my GOD! Do you ever say anything that's not stupid?! (n/m) - Z_Cherub 08:26:56 04/07/10 shut up. seriously. (n/m) - Antihero 09:53:45 04/07/10
Post a Followup	You cannot reply to this message because you are not logged in.