Subject	Question on New turbos
Posted by	mlaurie69 on March 19, 2010 at 6:24 PM
	This message has been viewed 84 times.
Message	So I have a new set of JWT500 turbos sitting here and I'm getting ready to install them. Also adding an APEXi electronic boost controller setup. Is there any adjustments or dial in procedure I need to do with the actuators before installing on the engine? Thanks Mark
Follow Ups	Question on New turbos - mlaurie69 18:24:59 03/19/10 Make sure they actuate at the same pressure. - spicyZ 18:37:43 03/19/10 What I learned when I installed Sport 500's - toyz 22:13:47 03/19/10 Re: What I learned when I installed Sport 500's - mlaurie69 23:19:20 03/19/10 Re: Re: What I learned when I installed Sport 500's - spicyZ 09:15:28 03/20/10 Does this apply to all turbos/ actuators? - ZXoltan 14:34:07 03/20/10
Post a Followup	You cannot reply to this message because you are not logged in.