Subject	Re: To replace valve stem seals, do the camshafts and pulleys
Posted by	Tech@EPR on March 17, 2010 at 5:40 PM
	This message has been viewed 137 times.
In Reply To	To replace valve stem seals, do the camshafts and pulleys posted by Quick_Z on March 17, 2010 at 04:33 PM
Message	[ http://toyotool.com/VMT6%20Buy.htm ] Worth the time in picking up. Also pick up a good set of valve seal pliers as well. makes the job much easier to handle. pressurize each chamber when each piston is at TDC. Just be careful not to drop any collets down in the head and so forth. it can be a pain in trying to find in all the oil thats in the heads.
Follow Ups	To replace valve stem seals, do the camshafts and pulleys - Quick_Z 16:33:48 03/17/10 Re: - Boris 16:45:12 03/17/10 Could you raise that specific piston to the top to keep - Quick_Z 17:05:56 03/17/10 Re: - Boris 17:49:40 03/17/10 No - that won't do it. Check around the net - some old - jzack 19:25:21 03/17/10 Re: To replace valve stem seals, do the camshafts and pulleys - Tech@EPR 17:40:11 03/17/10 Re: - BtheZman 20:42:28 03/17/10 Re: Re: - Tech@EPR 22:04:30 03/17/10
Post a Followup	You cannot reply to this message because you are not logged in.