Subject	How will it look painted on by brush or is it for compressor
Posted by	LivinTheDream on March 17, 2010 at 7:18 AM
	This message has been viewed 39 times.
In Reply To	POR-15 (n/m) posted by ZiNnYc on March 16, 2010 at 06:40 PM
Message	spray guns. "torque gets you off the line...& hp gets you over the line." - TTKeeper
Follow Ups	Question for the DIY rust warriors out there. - LivinTheDream 17:22:30 03/16/10 RI have some surface rust as well from what appears to - LJZTT 17:28:04 03/16/10 A tough as nails wire wheel and grinder if really needed. - LivinTheDream 17:35:38 03/16/10 POR-15 (n/m) - ZiNnYc 18:40:45 03/16/10 2nd. (n/m) - just4kinks 18:51:53 03/16/10 How will it look painted on by brush or is it for compressor - LivinTheDream 07:18:44 03/17/10 It has a similar texture/application to home paints. (n/m) - ZiNnYc 09:25:24 03/17/10 It goes on pretty smooth & is self leveling. - just4kinks 15:44:39 03/17/10 That sounds like a plan . I cleaned my bad areas up - xteam300tt 18:47:17 03/16/10 Thats where I wanted to order my topcoat and clear coat - LivinTheDream 07:08:21 03/17/10 Elbow grease and - Jehannum 19:00:26 03/16/10 any primer = epoxy primer if you're fighting rust. - fantomZ(OH) 20:36:49 03/16/10 Any primer will lift and bubble if rust is left underneath. - Jehannum 16:23:35 03/17/10 If the rust isn't too bad -- lightly sand and then apply - jzack 22:35:35 03/16/10
Post a Followup	You cannot reply to this message because you are not logged in.