Subject	wow you guys really want all the details
Posted by	cossiemodo2000 on March 14, 2010 at 6:13 PM
	This message has been viewed 46 times.
In Reply To	how do you remove your front wheels/ (n/m) posted by ali300zx on March 14, 2010 at 04:09 PM
Message	ok i said i put jacks on the appropriate spots, when its on the ramps, i use a floor jack to lift each side up about an inch and place the jacks on the frame rails, and yes there is room on my frame rail to lift an put the jack on the right place without damaging the frame rail.
Follow Ups	Using a jack @ the safety stand points? - evan_aggie 09:53:51 03/14/10 I roll up on a few 2x4's and jack from the cross memeber - zgene4 10:06:02 03/14/10 2nd. (n/m) - Wright (Ca) 10:50:24 03/14/10 3rd, I do the same, but use "rhino ramps" (n/m) - LJZTT 11:07:38 03/14/10 indeed (n/m) - vorpalZ 11:17:01 03/14/10 Thats a great way to f. up your car. (n/m) - Bernie (NoVA) 10:46:30 03/14/10 Re: Using a jack @ the safety stand points? - outkaZTT 10:49:51 03/14/10 Get a low profile jack, mine rolls under to the cross member - whip (Philly) 11:22:06 03/14/10 Which do you have? - evan_aggie 12:22:16 03/14/10 I think it's a "Big Red", got it at Pepboys. - whip (Philly) 13:03:13 03/14/10 Am I reading these responses right??? I would never jack my - cossiemodo2000 12:20:36 03/14/10 That's what the FSM says to do. See page GI-21 (n/m) - RAGTPZ 12:30:03 03/14/10 ... - 240Z FeO2 12:33:28 03/14/10 huge 2nd, it tears up. You'd need to have - Seb@Specialty-Z 12:39:07 03/14/10 Piece of wood works as well - yes? (n/m) - jzack 13:33:49 03/14/10 sure does. I effed mine up this way (n/m) - d_flore 23:24:34 03/15/10 What do you use? (n/m) - spicyZ 13:31:23 03/14/10 drive up ramps, then jack the rear from the diff with - cossiemodo2000 15:25:32 03/14/10 And if you need the front to be any higher? Then what? (n/m) - Eric(FL) 15:43:07 03/14/10 Honestly I don't know because the drive ramps i have, - cossiemodo2000 15:48:33 03/14/10 how do you remove your front wheels/ (n/m) - ali300zx 16:09:54 03/14/10 wow you guys really want all the details - cossiemodo2000 18:13:11 03/14/10 Front on ramps, and then jacking from rear? - spicyZ 17:57:31 03/14/10 i do it all the time - gt300zxtt 18:35:59 03/14/10 As long as you have a rubber pad it's fine (n/m) - BigTDogg (MA) 19:22:03 03/14/10 why not? (n/m) - vorpalZ 11:27:27 03/15/10 The front crossmember is the safest place to jack the front - Inzane 11:46:48 03/15/10 Rubber Saddle Pads, All Points,Always. - ttz'in (NorCal) 13:56:38 03/14/10 if your car is lowered - gt300zxtt 15:03:16 03/14/10 i dont know why you cant just go to a northern tool - gt300zxtt 18:33:45 03/14/10 Re: i dont know why you cant just go to a northern tool - flashstar 19:26:36 03/14/10
Post a Followup	You cannot reply to this message because you are not logged in.