Subject	Please give wheel specs. (Width and offset)
Posted by	KevinZtwin on March 09, 2010 at 2:49 AM
	This message has been viewed 94 times.
In Reply To	ssr professor sp1.. rolling fender question? posted by QuicknSlickz32 on March 08, 2010 at 09:06 PM
Message	From the sound of it, 1.5" is past "rolling" territory and more into the fender pulling/flaring arena of fender modding. Wheel specs will greatly help others help you. 353rwhp, 381rwtq, 91 pump, 15psi
Follow Ups	ssr professor sp1.. rolling fender question? - QuicknSlickz32 21:06:18 03/08/10 Re: ssr professor sp1.. rolling fender question? - ooofoo 21:52:34 03/08/10 If it is sticking out an inch and a half, rolling your - na300zx (OH) 21:59:11 03/08/10 Re: ssr professor sp1.. rolling fender question? - ztommyx 22:36:37 03/08/10 Please give wheel specs. (Width and offset) - KevinZtwin 02:49:15 03/09/10 You're gunna need to roll and pull - gnozahs 02:55:04 03/09/10 Offset is wrong, likely for a 350Z. If it's 37mm, it's too - Scotts94z32 11:48:08 03/09/10
Post a Followup	You cannot reply to this message because you are not logged in.