| Here: [ http://www.splparts.com/doc/SPLSDB/index.htm ]
SPL Parts
SPL solid differential bushings for
S14 and Z32
1. Remove differential from subframe.
2. Remove old rear differential mounting bushings from subframe.
3. Install aluminum bushings:
The bushings are designed to be a slightly tight fit, but as the mounting
holes on the subframe are not precisely round, some may have more difficulty
than others in installing these bushings. We have found some simple items
that can be used to "pull" in the bushing:
1/2" gas pipe flange
1/2" threaded rod some nuts and washers for threaded rod
Place the gas pipe flange on the opposite side of where the bushing is
started, and using the rod and nuts to press the bushing in.
PIC
Installed pic (with differential mounted up):
4. Remove old front differential mounting bushings from
differential. Install the new bushings. Note: On v1 bushings,
the main bushing piece goes from the top of the differential, and the spacer
piece goes on bottom as shown:
On v2 bushings, the bushings are symmetrical, simply press them in on both
sides of the pumpkin "ears".
5. Reinstall differential and front support bar, torque all bolts and
nuts to spec.
Written by Aikmeng Kuah, SPL PARTS
INC.
Oct 6 2004
Copyright SPL PARTS INC.
 Bernie Bilski berniebilski@cox.net
1995 Nissan 300ZX TwinTurbo in Cobalt Green
1997 Nissan 240SX SE in Ultra Red
ZCCNV #390 ~ ECZA #368 |
It's on the SPL website under techs... - 
