Subject	A heat gun does the trick to get the butyl seal.....
Posted by	Ziceman(East TN) on February 10, 2010 at 4:11 PM
	This message has been viewed 240 times.
In Reply To	Re: J Spec Tails Came In Yesterday... posted by Josher on February 10, 2010 at 03:43 PM
Message	loose. The stuff holds like a bear, so you will need to heat it first and also heat the new butyl seal to activate it once its installed with your new tail lights..
Follow Ups	J Spec Tails Came In Yesterday... - Z DNA 15:36:40 02/10/10 Nice buy Gerry - I think installing tail lights is in the - Bernie (NoVA) 15:42:49 02/10/10 Thanks Bernie.... - Z DNA 15:47:19 02/10/10 Definitely wait for warmer weather - Insomniac (VA) 16:06:48 02/10/10 yeah, don't try banging them out with a hammer (n/m) - Adam (NoVA) 16:23:16 02/10/10 Re: J Spec Tails Came In Yesterday... - Josher 15:43:38 02/10/10 A heat gun does the trick to get the butyl seal..... - Ziceman(East TN) 16:11:56 02/10/10 You need a 10mm, a 8mm and a phillips head screwdriver. - kickerzx 16:21:19 02/10/10 I forgot about the 8mm. - Josher 16:26:02 02/10/10 Pliers to release the pop clip on the center panel too. - Bernie (NoVA) 18:25:08 02/10/10 And an 8mm for the tail lights and center panel. (n/m) - Dave N 16:21:54 02/10/10 Re: J Spec Tails Came In Yesterday... - Marty1Mc 17:31:18 02/10/10 The lights come w. the sealer - it's in the box w. them. - Bernie (NoVA) 19:01:50 02/10/10 Don't freak out when the break light on the dash flashes.. - BeaZty 18:58:57 02/10/10 Just swap in your US bulbs. It's not that hard to figure out - Bernie (NoVA) 19:00:08 02/10/10 I was told the JDM bulbs have a higher wattage and - BeaZty 19:27:44 02/10/10 Whoever told you that is making things up - they have a - Bernie (NoVA) 19:37:02 02/10/10 AWESOME, thanks! - BeaZty 19:48:08 02/10/10 Brake>Break...:) (n/m) - MNZTTR 16:16:59 02/11/10 Thanks for all the advice. Can't wait to get them in ! ! (n/m) - Z DNA 12:50:23 02/11/10
Post a Followup	You cannot reply to this message because you are not logged in.