Subject	then you didn't do your research.
Posted by	Antihero on February 08, 2010 at 10:18 AM
	This message has been viewed 54 times.
In Reply To	I'm sure its in the FAQ, but for me... posted by puddlejumpinzx on February 07, 2010 at 01:42 PM
Message	top bolts are a peice of cake if you get a long extension and shoot from the back. Clutch job is waaaaay easier than a timing belt job. Two strong guys work better than a transmission jack. Antihero These 2530's ain't half bad ;)
Follow Ups	Ballpark, how much does a new stock clutch cost? - Zarcasm(Hfd, CT) 13:23:56 02/07/10 Buy an rps clutch, they are made in the USA, and have a good - bbsalexaz 13:30:06 02/07/10 do the pilot bushing, disk, pressure plate, and TOB. - KasbeKZ 13:39:07 02/07/10 I'm sure its in the FAQ, but for me... - puddlejumpinzx 13:42:41 02/07/10 Cost if you supply parts probably around 400+, DIY FTW (n/m) - puddlejumpinzx 13:45:51 02/07/10 it's been the same for me, but i just got a - KasbeKZ 14:03:31 02/07/10 Ha, yeah thats what i used, but they really put that bolt in - puddlejumpinzx 14:47:02 02/07/10 yeah no lie. after 3 drops though, i'm getting pretty good (n/m) - KasbeKZ 16:38:24 02/07/10 That and having a helper - ZXRider(SoCal) 17:10:04 02/07/10 Thanks for the insight guys (n/m) - Zarcasm(Hfd, CT) 18:11:40 02/07/10 then you didn't do your research. - Antihero 10:18:47 02/08/10 Is the 3' extension exactly the right length? - Zarcasm(Hfd, CT) 22:30:19 02/08/10 I would say easier than a plenum pull. - Spddracer 14:14:39 02/07/10 If you wanna DIY, you can borrow my tranny jack. - BigTDogg (MA) 14:39:31 02/07/10 Complete stock N/A clutch kit = $165 - Kyle(Houston) 15:04:44 02/07/10 = winner (n/m) - BigTDogg (MA) 15:11:59 02/07/10 DIY tranny jack + Thanks, Kyle - Zarcasm(Hfd, CT) 18:07:09 02/07/10 Sure, just shoot me an email if you do want it. - BigTDogg (MA) 21:45:34 02/07/10 Awesome... - Zarcasm(Hfd, CT) 22:47:46 02/07/10
Post a Followup	You cannot reply to this message because you are not logged in.