Subject	Wont work on the Z.
Posted by	Woody75 (Denver) on February 07, 2010 at 12:41 PM
	This message has been viewed 57 times.
In Reply To	DOHC lock tool question posted by njz on February 07, 2010 at 09:46 AM
Message	The exhaust cam gear has a ring around the outside edge which will prevent the pin in the tool from seating in the gear tooth area. JackB nimble JackB quick JackB can suck my dick =P - james-lee 11/02/01 Arrogance is the #1 weapon against Supra Owners - MikeH 08/06/02 Dallas with a Z: I like the bulge dude 05/02/03 Bezbefootball: Does dick have anything for me? 10/21/03
Follow Ups	DOHC lock tool question - njz 09:46:36 02/07/10 I use a similar tool on my A8. - Summeronthechain (MN) 09:57:17 02/07/10 What's the benefit? Keep the CAMs from rotating while - jzack 10:27:25 02/07/10 I don't see a need. It isn't hard to line them up (n/m) - Guapo 10:41:26 02/07/10 Re: I don't see a need. It isn't hard to line them up - njz 11:16:27 02/07/10 Yeah, I can see it being useful for holding the sprocket - Guapo 11:41:41 02/07/10 It's simple w/o tools. - zfreak(Dallas) 11:27:01 02/07/10 Re: DOHC lock tool question - MrOzzie5183 11:49:12 02/07/10 do you have a link? (n/m) - aliaZ 12:28:36 02/07/10 Wont work on the Z. - Woody75 (Denver) 12:41:38 02/07/10 Thanks woody, I gurss this type is out. (n/m) - njz 13:29:01 02/07/10 Buy the tool MGH makes. (n/m) - canyoncarver 13:04:35 02/07/10 Re: Buy the tool MGH makes. - njz 13:30:14 02/07/10 Snap On makes a few tools for this also - 300MPH 15:27:25 02/07/10 Link - canyoncarver 06:25:57 02/08/10 Zip ties work good for me (n/m) - the80proof 13:33:04 02/07/10 *well (n/m) - Bernie (NoVA) 23:24:15 02/07/10 unnecessary. (n/m) - Halo Z 16:17:31 02/07/10 I used zip ties on a timing belt job for a saturn's DOHC V6. - KongZTT GT28RS MD 10:20:16 02/08/10
Post a Followup	You cannot reply to this message because you are not logged in.