Subject	Re: DOHC lock tool question
Posted by	MrOzzie5183 on February 07, 2010 at 11:49 AM
	This message has been viewed 78 times.
In Reply To	DOHC lock tool question posted by njz on February 07, 2010 at 09:46 AM
Message	i dig on tools, how much does this thing cost and will it be strong enough to hold up against the 90 odd ft lbs of torque?
Follow Ups	DOHC lock tool question - njz 09:46:36 02/07/10 I use a similar tool on my A8. - Summeronthechain (MN) 09:57:17 02/07/10 What's the benefit? Keep the CAMs from rotating while - jzack 10:27:25 02/07/10 I don't see a need. It isn't hard to line them up (n/m) - Guapo 10:41:26 02/07/10 Re: I don't see a need. It isn't hard to line them up - njz 11:16:27 02/07/10 Yeah, I can see it being useful for holding the sprocket - Guapo 11:41:41 02/07/10 It's simple w/o tools. - zfreak(Dallas) 11:27:01 02/07/10 Re: DOHC lock tool question - MrOzzie5183 11:49:12 02/07/10 do you have a link? (n/m) - aliaZ 12:28:36 02/07/10 Wont work on the Z. - Woody75 (Denver) 12:41:38 02/07/10 Thanks woody, I gurss this type is out. (n/m) - njz 13:29:01 02/07/10 Buy the tool MGH makes. (n/m) - canyoncarver 13:04:35 02/07/10 Re: Buy the tool MGH makes. - njz 13:30:14 02/07/10 Snap On makes a few tools for this also - 300MPH 15:27:25 02/07/10 Link - canyoncarver 06:25:57 02/08/10 Zip ties work good for me (n/m) - the80proof 13:33:04 02/07/10 *well (n/m) - Bernie (NoVA) 23:24:15 02/07/10 unnecessary. (n/m) - Halo Z 16:17:31 02/07/10 I used zip ties on a timing belt job for a saturn's DOHC V6. - KongZTT GT28RS MD 10:20:16 02/08/10
Post a Followup	You cannot reply to this message because you are not logged in.