Subject	perhaps a piece of stainless steel on the underside or on
Posted by	REDI4U on January 27, 2010 at 4:48 PM
	This message has been viewed 91 times.
In Reply To	date skinnier girls (n/m) posted by LJZTT on January 27, 2010 at 04:45 PM
Message	top before I have it covered or replaced to reinforce ???
Follow Ups	Anyone fab up a center console lid? - Shiers69 14:48:36 01/27/10 I dont know about you - ZiNnYc 16:07:06 01/27/10 mine isn't holding hella good (n/m) - ali300zx 16:22:41 01/27/10 2nd mine is collapsing in the middle (n/m) - REDI4U 16:29:34 01/27/10 I weigh 190 lbs, and my arms arent exactly small. - ZiNnYc 16:37:33 01/27/10 I've heard mine crack a few times with the elbow in it. (n/m) - Spddracer 16:39:41 01/27/10 if mine wasn't at paint shop I would take a pic it is bad - REDI4U 16:43:03 01/27/10 yep - Drk93TT 18:17:48 01/27/10 date skinnier girls (n/m) - LJZTT 16:45:16 01/27/10 perhaps a piece of stainless steel on the underside or on - REDI4U 16:48:53 01/27/10 Re: perhaps a piece of stainless steel on the underside or on - ali300zx 17:23:46 01/27/10 His door panel arm rests are replacements (n/m) - REDI4U 12:52:32 01/28/10 Re: Anyone fab up a center console lid? - Izzy 18:30:17 01/27/10 I took mine apart and layered fiberglass mesh - Trailboss 21:31:04 01/27/10 FWIW - This repair has held up extremely well, pretty - jzack 22:54:40 01/27/10 We've done similar work and agreed -it does hold up. (n/m) - Bernie (NoVA) 23:00:55 01/27/10 Yup... and now that lid falls closed with authority. (n/m) - Karl (MD) 23:12:19 01/27/10 now I like the Goop idea (n/m) - REDI4U 08:03:23 01/28/10 I've done that and it works very nicely! (n/m) - Graphx007 08:08:34 01/28/10 Kmahmood has replacements and alternative colors/stitching - Z_Cherub 09:21:56 01/28/10 Kmahmood has replacement lids or just the covers? (n/m) - Shiers69 09:56:58 01/28/10 I was under the impression that they were replacements, - Z_Cherub 10:35:52 01/28/10 They're just the coverings, not the whole lid (n/m) - Shiers69 13:45:36 01/28/10
Post a Followup	You cannot reply to this message because you are not logged in.