Subject	Line up properly and seal? Care to elaborate?
Posted by	The Hawk on January 15, 2010 at 9:16 PM
	This message has been viewed 114 times.
In Reply To	i found the JWT difficult to line up properly and to seal up (n/m) posted by MixManMash on January 15, 2010 at 09:12 PM
Message	Takes a screwdriver and about 10 mins IMO....
Follow Ups	Selin Dual MAF install - njz 19:26:14 01/15/10 I helped a friend install one and the fit was - ShakaShaun(Denver) 20:45:18 01/15/10 i found the JWT difficult to line up properly and to seal up (n/m) - MixManMash 21:12:55 01/15/10 Line up properly and seal? Care to elaborate? - The Hawk 21:16:45 01/15/10 Twice as many clamps. Everytime I tighten down the worm - MixManMash 22:09:18 01/15/10 Re: Twice as many clamps. Everytime I tighten down the worm - txq45 22:38:16 01/15/10 T-bolts are ridiculous overkill for a low-pressure system. (n/m) - Inzane 23:18:54 01/15/10 Re: T-bolts are ridiculous overkill for a low-pressure system. - txq45 08:17:45 01/16/10 Agreed, but you can get a worm gear style clamp - MixManMash 10:37:57 01/16/10 Those exact clamps are included in the kit... - CaliguyPurdue (Selin Design) 13:10:39 01/16/10 Agreed! (n/m) - MixManMash 15:39:22 01/16/10 Breeze clamps - BigTDogg (MA) 17:00:33 01/16/10 Tried that too. The T-bolts that fit are too wide to make a - MixManMash 10:35:35 01/16/10 Has anyone tried running it with a doolz set up instead - john90zxtt(OH) 21:18:15 01/15/10 Why not just use the JWT elbows and you have the best of - Spawn 21:21:19 01/15/10 bingo - LJZTT 06:13:00 01/16/10 I found the Selin fitment much better than the JWT - vorpalZ 10:19:35 01/16/10 same experience here (n/m) - ztunerz 12:47:20 01/16/10 Same here. (n/m) - Woody75 (Denver) 09:36:30 01/17/10 If the elbows are a bit too long, as a last resort, - 240Z FeO2 22:18:54 01/15/10
Post a Followup	You cannot reply to this message because you are not logged in.