Subject	sounds expensive... (n/m)
Posted by	dpjax on December 21, 2009 at 10:23 AM
	This message has been viewed 61 times.
In Reply To	Parts list. Care to review? posted by rojoloco (San Diego) on December 21, 2009 at 08:48 AM
Message
Follow Ups	Parts list. Care to review? - rojoloco (San Diego) 08:48:48 12/21/09 Re: Parts list. Care to review? - ZonaZ 09:06:27 12/21/09 A few problems. - rojoloco (San Diego) 09:30:28 12/21/09 Re: A few problems. - ultra red 93 10:59:17 12/21/09 ummmmm you cannot afford $50 for a new program? (n/m) - dream Z (MD) 09:59:09 12/22/09 My last reflash was about $350. When did they get so cheap? (n/m) - rojoloco (San Diego) 22:17:05 12/22/09 get two driver side PCV hoses for the reroute. (n/m) - SuparexTT 09:11:47 12/21/09 *pass side (n/m) - ZiNnYc 13:17:34 12/21/09 longblock for sure! - ali300zx 09:16:11 12/21/09 Already have the knock sensor and harness. - rojoloco (San Diego) 09:32:58 12/21/09 sounds expensive... (n/m) - dpjax 10:23:52 12/21/09 I'm hoping no more than 9-10k. I'm probably wrong. (n/m) - rojoloco (San Diego) 22:44:52 12/21/09 You've got one redundancy there: - BigTDogg (MA) 11:29:58 12/21/09 Thanks! - rojoloco (San Diego) 22:49:38 12/21/09 I would check Harry (ztunerz) and SZ to see if their - BigTDogg (MA) 08:48:16 12/22/09 I am very happy with my sz chip and clock program selector - HighPsi 09:45:53 12/22/09 I'll definitely pick his brain here soon as I draw closer. (n/m) - rojoloco (San Diego) 06:12:57 12/23/09 why do you think you can change injector sizes w/out - Adam (NoVA) 15:53:53 12/22/09 Wasn't sure about this one. - rojoloco (San Diego) 22:15:37 12/22/09 Get the coated pistons option from Kyle. I read up on it - zellamay 12:21:15 12/21/09 What makes it worth the money exactly? - rojoloco (San Diego) 22:50:44 12/21/09 Hi Travis. Have you diagnosed why you have low compression? - BoneZ 14:13:18 12/21/09 My only concern here is wasting money. - rojoloco (San Diego) 22:44:09 12/21/09 I'm with you on buying a block over having it rebuilt - BoneZ 15:20:48 12/22/09
Post a Followup	You cannot reply to this message because you are not logged in.