Subject	So its about that time.
Posted by	ZiNnYc on November 25, 2009 at 9:36 AM
	This message has been viewed 204 times.
Message	full front clip x series clutch full 120K rameyZ idler pulley studs DPs + TPs EBC rear main seal "kit" EGR delete radiator relocation kit new lines for actuators new heater hoses ECU reflashed things to "do" inspect oil lines for blockages inspect VTC gears flush coolant if plenum is pulled (debating over whether I should do this now or later since I can pull plenum anytime) water bypass knock sensor and harness R&R valve cover gaskets waiting on SZ for a Selin kit what else would you purchase when trying to get the car back on road ASAP in the most efficient manner ********
Follow Ups	So its about that time. - ZiNnYc 09:36:34 11/25/09 Anything you can do to the motor while it's out - Guapo 09:59:19 11/25/09 Which answers your question about when to pull the plenum. (n/m) - 240Z FeO2 11:34:30 11/25/09 Your list doesn't look bad - collegeboy 10:17:16 11/25/09 2nd on harness and may have to replace jspec turbos - MikeVar82 10:18:08 11/25/09 I have mine out and here's what's being done: - RageLtMan 16:14:57 11/25/09
Post a Followup	You cannot reply to this message because you are not logged in.