Subject	probably 87.5mm
Posted by	aliaZ on November 15, 2009 at 6:22 PM
	This message has been viewed 72 times.
In Reply To	rebuilding engine, piston and rod?? posted by supersh0cker on November 15, 2009 at 05:37 PM
Message	best bet is to have your machine shop tell you the minimum over bore needed and go from there Kyle at [ www.importpartspro.com ] can help you with the parts when you're ready
Follow Ups	rebuilding engine, piston and rod?? - supersh0cker 17:37:48 11/15/09 Re: rebuilding engine, piston and rod?? - txq45 17:59:05 11/15/09 Kyle... importpartspro, has everything you need - zgene4 18:22:02 11/15/09 2nd...Great service from Kyle (n/m) - TTZMatt 18:35:07 11/15/09 Use Kyle - AC[dover] 20:15:45 11/15/09 3rd... currently breaking in my IPP block - vorpalZ 09:31:14 11/16/09 4th. Should have bought from Kyle - Jehannum 10:12:13 11/16/09 probably 87.5mm - aliaZ 18:22:21 11/15/09 Re: probably 87.5mm - supersh0cker 19:44:34 11/15/09 Likely dont need new rods - ZXoltan 20:07:43 11/15/09
Post a Followup	You cannot reply to this message because you are not logged in.