Subject	Installing factory precats
Posted by	RedTTZ91(OK) on November 07, 2009 at 4:54 PM
	This message has been viewed 347 times.
Message	Does the pass. side precat angle sharply toward the starer? to where you would have to remove the small peice of the starter heatshield to slide it on? like so? http://i113.photobucket.com/albums/n240/importuners01/IMG_0290.jpg ]"> Just trying to make sure I got the correct ones going on.
Follow Ups	Installing factory precats - RedTTZ91(OK) 16:54:56 11/07/09 fixed pic - RedTTZ91(OK) 17:16:47 11/07/09 If this is a precat identification question, maybe this - 240Z FeO2 18:54:21 11/07/09 Why are you installing the OEM precats? (n/m) - ZXRider(SoCal) 17:26:40 11/07/09 Re: Why are you installing the OEM precats? - RedTTZ91(OK) 18:26:13 11/07/09 I purchased a set of - ZXRider(SoCal) 18:29:09 11/07/09 Re: Anything is better than installing the OEM precats. - zgene4 18:59:15 11/07/09 yesum! 3rd. However if everything is OEM then you should - d_flore 20:01:13 11/07/09 Or he can just gut them. Even that would be better. (n/m) - rojoloco (San Diego) 20:04:12 11/07/09 Eh, I wouldn't argue that without having a look at exactly - turtleboy 11:43:33 11/08/09 I would ship you a set of down pipes if I still had them. (n/m) - nissanguyz32 20:01:18 11/07/09 i kno right. the oem ones are horrible. (n/m) - JustinSCZ32 21:05:56 11/07/09
Post a Followup	You cannot reply to this message because you are not logged in.