Subject	I feel that AVE is better
Posted by	Carlos Ramirez on November 01, 2009 at 8:04 PM
	This message has been viewed 238 times.
In Reply To	ok.. for the Add or Average, whats what posted by JustinSCZ32 on November 01, 2009 at 07:35 PM
Message	See I see two important limits resolved with dual pop. 1. Less air flow restriction 2. More air flow capacity If you have an ECU for a single POP and you put in a dual selin kit you will take advantage of better air flow. And thus make more power. This is in ADD mode. But say you got some turbos that make over 450RWHP a conservative limit for the a single stock MAF. Then you would for sure need to do AVE and have the ecu remapped for dual pops. This is in AVE mode. I hope this helps. Now for me I like the old fasion AFC plus a second MAF only because you can do so simple a/f corrections.
Follow Ups	Selin install. Thanks Jim! - Tu 18:33:49 11/01/09 Nice! - DVDBURN (MD) 19:21:29 11/01/09 One thing I might mention too is... - DVDBURN (MD) 20:42:49 11/01/09 Re: One thing I might mention too is... - BanzaiZX 03:38:40 11/02/09 Correct, my unit uses a processor in this way - CaliguyPurdue (Selin Design) 11:38:28 11/02/09 Yes, the ECU converts the analog MAF input signal... - DVDBURN (MD) 12:03:01 11/02/09 This is a circuit based on analog operational amplifier. - Dark Diver 08:29:06 11/02/09 Re: This is a circuit based on analog operational amplifier. - BanzaiZX 09:34:44 11/02/09 That's exactly what I said : - Dark Diver 17:25:12 11/02/09 This circuit is incorrect. Details inside... - CaliguyPurdue (Selin Design) 11:34:11 11/02/09 Here's a picture of the bare boards... - CaliguyPurdue (Selin Design) 12:36:53 11/02/09 very impressive sir. Was wondering what was on the inside. - Tu 12:53:09 11/02/09 Sorry. I didn't mean to imply that your design was inferior - DVDBURN (MD) 14:40:39 11/02/09 Bye bye JIM Wolf hello JIM Selin :-) - ArubaDave 21:11:53 11/02/09 I agree and disagree with that : - Dark Diver 17:56:57 11/02/09 You are very correct. - DVDBURN (MD) 12:34:25 11/03/09 ok.. for the Add or Average, whats what - JustinSCZ32 19:35:46 11/01/09 I would assume add is for normal ECUs - collegeboy 20:00:20 11/01/09 I think its the exact opposite. - J-Mart 08:40:43 11/02/09 I am WRONG! I better go check my SAFC settings... - J-Mart 08:52:57 11/02/09 yup (n/m) - ali300zx 08:48:01 11/02/09 I feel that AVE is better - Carlos Ramirez 20:04:47 11/01/09 Not sure about the Selin, but when using an SAFC, the ADD - zgene4 20:23:34 11/01/09 Re: I feel that AVE is better - BanzaiZX 04:12:04 11/02/09 6 of one, half dozen of the other, just depends on EPROM (n/m) - BigTDogg (MA) 10:06:23 11/02/09 ADD is for a "single pop ECU" but you'll encounter the 500HP - Dark Diver 18:00:04 11/02/09 Nice! (n/m) - Musashi Sword 19:44:26 11/01/09 did you install the centre T-bolts before installing the - vorpalZ 21:05:10 11/01/09 I had both filters off for the final fit. I like easy. (n/m) - Tu 12:41:31 11/02/09 Thanks Tu! Great pictures and post.. - CaliguyPurdue (Selin Design) 11:42:59 11/02/09
Post a Followup	You cannot reply to this message because you are not logged in.