TwinTurbo.NET: Nissan 300ZX forum - My reason for the load leveler
People Seeking Info
 
   


     
Subject My reason for the load leveler
     
Posted by intel on October 22, 2009 at 12:00 AM
  This message has been viewed 60 times.
     
In Reply To Engine pull question -- how much of a help was that posted by jzack on October 21, 2009 at 06:44 PM
     
Message was because of the rather awkward setup of my garage. I basically had to move the engine to the area above the engine bay by going over the fender with the jackstands at their lowest setting.

Doing that by myself without the leveler would have been difficult as I was able to rotate the engine forward to help it clear the oil pan/downpipes. Also saved the day for putting in putting in Zgene's engine with even tighter clearance issues with his garage door.

If you look in the lower right you can see the 3 inch ledge that is the bane of the garage.
[ http://www.youtube.com/user/kramneslo#p/a/u/0/ADs59RvKExc ]

Installing the ARP studs/heads
[ http://www.youtube.com/watch?v=TzMWZMwnLfg ]

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.