Subject	Niiiiiice Ryan.
Posted by	Hawkin"Z" on October 09, 2009 at 8:05 PM
	This message has been viewed 70 times.
In Reply To	How did you run the harness for your wideband? posted by thejoneZ (Sacto, CA) on October 09, 2009 at 04:56 PM
Message	I was going to ask you what you've been up to...but now I know :-) Awesome work man.
Follow Ups	How did you run the harness for your wideband? - thejoneZ (Sacto, CA) 16:56:41 10/09/09 Shifter port is where people usually run it, from posts - BigTDogg (MA) 17:54:32 10/09/09 Re: Shifter port is where people usually run it, from posts - thejoneZ (Sacto, CA) 17:59:42 10/09/09 Just running your TT ecu until you get the AEM tuned? - Shiers69 18:08:43 10/09/09 Re: Just running your TT ecu until you get the AEM tuned? - thejoneZ (Sacto, CA) 18:19:33 10/09/09 I take that back... - thejoneZ (Sacto, CA) 18:24:47 10/09/09 It is not available yet... - BOOZTD 3 21:52:09 10/09/09 I ran mine up into the engine bay then through the firewall. - d_flore 18:37:41 10/09/09 I bent the shifter plate and trans tunnel slightly to make - zgene4 18:48:05 10/09/09 Re: I bent the shifter plate and trans tunnel slightly to make - thejoneZ (Sacto, CA) 19:02:18 10/09/09 I hope u put some sort of protectent so that the wires dont - d_flore 22:26:02 10/09/09 not my first rodeo (n/m) - zgene4 23:40:35 10/09/09 Niiiiiice Ryan. - Hawkin"Z" 20:05:18 10/09/09 Slowly but surely :) (n/m) - thejoneZ (Sacto, CA) 01:22:42 10/10/09 I would rewire the wideband... - BOOZTD 3 21:53:41 10/09/09 uhh u sure? why? (n/m) - d_flore 22:25:01 10/09/09 ground offset (n/m) - aliaZ 22:55:06 10/09/09 wideband readings are based on voltage variences that are - zgene4 23:44:32 10/09/09 Re: I would rewire the wideband... - thejoneZ (Sacto, CA) 01:24:46 10/10/09 here is an interesting read on ground offsets - aliaZ 09:17:29 10/10/09 Thanks Don. - thejoneZ (Sacto, CA) 13:11:34 10/10/09 Wow there are a lot of differing opinions there :) - thejoneZ (Sacto, CA) 13:39:54 10/10/09
Post a Followup	You cannot reply to this message because you are not logged in.