TwinTurbo.NET: Nissan 300ZX forum - I bent the shifter plate and trans tunnel slightly to make
People Seeking Info
 
   


     
Subject I bent the shifter plate and trans tunnel slightly to make
     
Posted by zgene4 on October 09, 2009 at 6:48 PM
  This message has been viewed 147 times.
     
In Reply To How did you run the harness for your wideband? posted by thejoneZ (Sacto, CA) on October 09, 2009 at 04:56 PM
     
Message enough room for the harness to sneak through. I have an Innovate LC-1 and had to extend the sensor harness about 1.5' so I could keep the controller portion mounted inside the car.


"Too dumb for opera, too smart for NASCAR."

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.