Subject	No the threaded pin has performed w/o incident. In fact
Posted by	Gordo 93TT Daytona on October 02, 2009 at 11:24 PM
	This message has been viewed 65 times.
In Reply To	Have you had any problems with the adjustable clutch slave posted by ZEVAN (Ca) on October 02, 2009 at 04:30 PM
Message	I recently adjusted the pedal height upward by extending the pin length at the slave cylinder. As long as one maintains full piston travel at the master and slave cylinders, extending the pin length at the fork has no effect on the hydraulics. It was much easier than contorting oneself under the dash to thread out the adjustment at the clutch pedal. _________________________________________________
Follow Ups	Stillen Rear Camber Adj Arm Update and Acknowlegement - Gordo 93TT Daytona 09:57:52 10/02/09 glad you figured it out...2nd on the tt.net community (n/m) - dpjax 10:05:46 10/02/09 Have you had any problems with the adjustable clutch slave - ZEVAN (Ca) 16:30:41 10/02/09 No the threaded pin has performed w/o incident. In fact - Gordo 93TT Daytona 23:24:03 10/02/09 Glad to hear. Thanks. (n/m) - ZEVAN (Ca) 00:24:44 10/03/09 Happy to help - Rob'Z 18:21:50 10/03/09
Post a Followup	You cannot reply to this message because you are not logged in.