Subject	I guess I should have clarified, that the basis for my
Posted by	zgene4 on October 01, 2009 at 7:57 PM
	This message has been viewed 36 times.
In Reply To	Nope, third port wasn't the answer. posted by brahmabull (MD) on October 01, 2009 at 07:28 PM
Message	testing would be with the solenoid on the test bench, a 12V power supply, and a short length of hose to put in your mouth to blow air through the solenoid ports until you find the proper two port combo that lets air flow with no power applied and stops it with power applied. "Too dumb for opera, too smart for NASCAR."
Follow Ups	Profec B Spec 1 EBC and Perrin EBC Solenoid - brahmabull (MD) 16:57:21 10/01/09 Did it come w/ instructions? - Bernie (NoVA) 17:01:12 10/01/09 Yes, we hooked it up as directed. - brahmabull (MD) 17:08:20 10/01/09 Don't mention my name - governor 18:26:18 10/01/09 I installed the perrin solenoid on my type S. - jmw23712 17:03:57 10/01/09 I agree... - brahmabull (MD) 17:08:09 10/01/09 It's likely a problem with how you plumbed the solenoid - zgene4 17:31:43 10/01/09 Do the Greddy solenoids bleed off air through the third - ZEVAN (Ca) 18:11:37 10/01/09 Thanks, I'll try the third port and see how that goes. (n/m) - brahmabull (MD) 18:26:41 10/01/09 Nope, third port wasn't the answer. - brahmabull (MD) 19:28:48 10/01/09 I guess I should have clarified, that the basis for my - zgene4 19:57:51 10/01/09 Welcome back - ZXRider(SoCal) 23:19:04 10/01/09 Thanks Ben. I'm still around. Don't post much. - brahmabull (MD) 07:55:45 10/02/09 GM solenoids work as well. - apudapus 04:16:49 10/02/09 do these work with the Greddy Profec2? (n/m) - JustinSCZ32 14:28:53 10/02/09 oops, didnt read your profile.. Why are you runing dual - JustinSCZ32 14:32:55 10/02/09 i had the profec b and perrin solenoid setup before. - RedSER13 09:43:50 10/02/09
Post a Followup	You cannot reply to this message because you are not logged in.