Subject	I agree...
Posted by	brahmabull (MD) on October 01, 2009 at 5:08 PM
	This message has been viewed 38 times.
In Reply To	I installed the perrin solenoid on my type S. posted by jmw23712 on October 01, 2009 at 05:03 PM
Message	I don't feel as if it has the adjustability. I had the connector from my old Greddy unit spliced into the Perrin solenoid. I read on tt.net that it didn't matter how the wires were spliced (which wire connected to which). Which ports did you use? Port 1 was on the left. Port 2 and 3 were on the right with 2 on top. Raj
Follow Ups	Profec B Spec 1 EBC and Perrin EBC Solenoid - brahmabull (MD) 16:57:21 10/01/09 Did it come w/ instructions? - Bernie (NoVA) 17:01:12 10/01/09 Yes, we hooked it up as directed. - brahmabull (MD) 17:08:20 10/01/09 Don't mention my name - governor 18:26:18 10/01/09 I installed the perrin solenoid on my type S. - jmw23712 17:03:57 10/01/09 I agree... - brahmabull (MD) 17:08:09 10/01/09 It's likely a problem with how you plumbed the solenoid - zgene4 17:31:43 10/01/09 Do the Greddy solenoids bleed off air through the third - ZEVAN (Ca) 18:11:37 10/01/09 Thanks, I'll try the third port and see how that goes. (n/m) - brahmabull (MD) 18:26:41 10/01/09 Nope, third port wasn't the answer. - brahmabull (MD) 19:28:48 10/01/09 I guess I should have clarified, that the basis for my - zgene4 19:57:51 10/01/09 Welcome back - ZXRider(SoCal) 23:19:04 10/01/09 Thanks Ben. I'm still around. Don't post much. - brahmabull (MD) 07:55:45 10/02/09 GM solenoids work as well. - apudapus 04:16:49 10/02/09 do these work with the Greddy Profec2? (n/m) - JustinSCZ32 14:28:53 10/02/09 oops, didnt read your profile.. Why are you runing dual - JustinSCZ32 14:32:55 10/02/09 i had the profec b and perrin solenoid setup before. - RedSER13 09:43:50 10/02/09
Post a Followup	You cannot reply to this message because you are not logged in.