TwinTurbo.NET: Nissan 300ZX forum - Wish I knew this last week, I just threw out one that has
Subject
Wish I knew this last week, I just threw out one that has
Posted by
DavezTT
on October 01, 2009 at 9:50 AM
This message has been viewed
46
times.
In Reply To
Is it possible to install a new ring gear on the oem
posted by ZEVAN (Ca)
on October 01, 2009 at 09:39 AM
Message
been sitting around for a couple of years. Would have given it to you. I may have one off an old tt engine but it was an automatic, does that matter. Email me if your interested.
Follow Ups
Is it possible to install a new ring gear on the oem
-
ZEVAN (Ca)
09:39:40 10/01/09
Wish I knew this last week, I just threw out one that has -
DavezTT
09:50:34 10/01/09
The auto flywheel,(flexplate), will not work for a manual. (n/m)
-
Fast300
10:15:19 10/01/09
After I thought about it, I figured it wouldn't. I was
-
DavezTT
10:22:05 10/01/09
Four here :-) (n/m)
-
Fast300
15:11:48 10/01/09
You can buy replacement ring gears from a Nissan/Z vendor
-
LitlElvis
10:35:14 10/01/09
Thank you. I see courtesy parts list it for $90. (n/m)
-
ZEVAN (Ca)
10:48:01 10/01/09
You can have my stock tt flywheel for whatever they usually
-
collegeboy
11:07:25 10/01/09
Question 2: anyone know what is different between the two
-
ZEVAN (Ca)
10:53:07 10/01/09
I have a stock one already resurfaced as a back up I can
-
Nis300owner
13:51:11 10/01/09
Post a
Followup
You cannot reply to this message because you are not
logged in
.