Subject	happened to mine.
Posted by	Alan(MD/NJ) on September 29, 2009 at 3:07 PM
	This message has been viewed 63 times.
In Reply To	looking for some insight on a couple of issues that my z is posted by cossiemodo2000 on September 29, 2009 at 03:01 PM
Message	I needed to replace my master clutch cylinder Z is currently under renovation, inside and out, pardon her appearance:
Follow Ups	looking for some insight on a couple of issues that my z is - cossiemodo2000 15:01:53 09/29/09 happened to mine. - Alan(MD/NJ) 15:07:55 09/29/09 mine did that and it ended up being the slave cylinder (n/m) - Nis300owner 15:19:32 09/29/09 Will it go into reverse with the engne off? (n/m) - Spddracer 16:12:33 09/29/09 nope (n/m) - cossiemodo2000 17:18:11 09/29/09 Then it is most likely not a clutch issue - Spddracer 20:53:31 09/29/09 speedo works fine, where is the reverse lock out?? (n/m) - cossiemodo2000 22:07:16 09/29/09 could be a pedal adjustment, bleeding or slave cylinder - ForceFedTT (SoCal) 16:26:13 09/29/09 Man that just sucks. You need to be out enjoying that build! (n/m) - Musashi Sword 17:09:04 09/29/09 Did you also try letting it roll forward or back while - Ashman2k2 01:14:57 09/30/09 Check the slave cylinder. Push the boot and see if fluid - boileralum 17:58:01 09/30/09 guys there is no fluid loss and all other gears work fine - cossiemodo2000 03:25:52 10/01/09
Post a Followup	You cannot reply to this message because you are not logged in.