Subject	looking for some insight on a couple of issues that my z is
Posted by	cossiemodo2000 on September 29, 2009 at 3:01 PM
	This message has been viewed 144 times.
Message	having. Ok so I finally broke my motor in, fixed all boost leaks, only to realize that my 7000mile rps clutch was slipping. I adjusted the pedal per SZ write up, and re bled the system multiple times, still no difference. Yesterday I parked the z and when I came back it did not want to go into reverse! Manual tranny btw. I tried for 10 min double clutching, putting it in first and then trying reverse and etc... As of today still will not go into reverse gear! it feels as if there is no slit for the gear to go into, do you guys think that my tranny is done?? every other gear works flawlesly, or is it my clutch issue?
Follow Ups	looking for some insight on a couple of issues that my z is - cossiemodo2000 15:01:53 09/29/09 happened to mine. - Alan(MD/NJ) 15:07:55 09/29/09 mine did that and it ended up being the slave cylinder (n/m) - Nis300owner 15:19:32 09/29/09 Will it go into reverse with the engne off? (n/m) - Spddracer 16:12:33 09/29/09 nope (n/m) - cossiemodo2000 17:18:11 09/29/09 Then it is most likely not a clutch issue - Spddracer 20:53:31 09/29/09 speedo works fine, where is the reverse lock out?? (n/m) - cossiemodo2000 22:07:16 09/29/09 could be a pedal adjustment, bleeding or slave cylinder - ForceFedTT (SoCal) 16:26:13 09/29/09 Man that just sucks. You need to be out enjoying that build! (n/m) - Musashi Sword 17:09:04 09/29/09 Did you also try letting it roll forward or back while - Ashman2k2 01:14:57 09/30/09 Check the slave cylinder. Push the boot and see if fluid - boileralum 17:58:01 09/30/09 guys there is no fluid loss and all other gears work fine - cossiemodo2000 03:25:52 10/01/09
Post a Followup	You cannot reply to this message because you are not logged in.