Subject	marketing-hype. This stuff says "2000 F"
Posted by	Nick(CT) on September 10, 2009 at 7:03 PM
	This message has been viewed 131 times.
In Reply To	then what is the point of the stuff it says its good to 650 posted by d_flore on September 10, 2009 at 06:47 PM
Message	and it'll start smoking within seconds next to a hot turbo......I also hung it in front of a propane flame to see how close it could get before igniting, and it started disintegrating within 6 inches of the flame and then igniting. [ http://www.summitracing.com/parts/DEI-010479/ ]
Follow Ups	High heat silicone a bad idea on turbo hot pipe right near - d_flore 18:08:27 09/10/09 Terrible idea - Dont do it, because it'll probably turn into - Nick(CT) 18:15:28 09/10/09 why? (n/m) - d_flore 18:19:52 09/10/09 High heat stuff will smoke and eventually flame-up (n/m) - Nick(CT) 18:38:47 09/10/09 then what is the point of the stuff it says its good to 650 - d_flore 18:47:30 09/10/09 marketing-hype. This stuff says "2000 F" - Nick(CT) 19:03:32 09/10/09 even if it is good to 650F... - ZLover4Life 19:18:09 09/10/09 It is hard to see for sure but it seems my intercooler pipe - d_flore 19:40:14 09/10/09 should do the job - ali300zx 20:25:01 09/10/09 There's no way I'd use silicone on that - ZLover4Life 20:53:27 09/10/09 EGT's and the turbine housing will get to 1500F - RHulme 19:28:48 09/10/09 Turbine side? No, bad idea (n/m) - BigTDogg (MA) 19:53:37 09/10/09 I think he means the turbo outlet (pressure side) - Seb@Specialty-Z 20:12:43 09/10/09 Yeah i do. I actually found out that it was shadows playing - d_flore 20:37:16 09/10/09
Post a Followup	You cannot reply to this message because you are not logged in.