Subject	Hosing to replace all the under plenum coolant lines or
Posted by	jzack on August 23, 2009 at 4:17 PM
	This message has been viewed 105 times.
In Reply To	Pulling Plenum to do injectors. Any parts needed besides posted by d_flore on August 23, 2009 at 02:26 PM
Message	just eliminate them via a bypass. Also a good time to do a little MTCE on the air idle control valve at back of plenum -- there's a nice How-to FAQ posted (very simple job). Probably will need a new plenum gasket for that valve too...
Follow Ups	Pulling Plenum to do injectors. Any parts needed besides - d_flore 14:26:29 08/23/09 Upper plenum gasket (n/m) - BigTDogg (MA) 14:38:55 08/23/09 New injector O rings and manifold to fuel rail insulators (n/m) - ZUL8TR 14:44:17 08/23/09 Re: Pulling Plenum to do injectors. Any parts needed besides - ouikikazz 14:47:18 08/23/09 Hosing to replace all the under plenum coolant lines or - jzack 16:17:23 08/23/09 valve cover gaskets and pcv valves. might as well do - Dane (Houston) 17:47:41 08/23/09 Without question, replace your - zgene4 19:44:10 08/23/09 There is always a few (n/m) - dawhip 21:31:26 08/23/09 Arrr. (n/m) - AbsolutZ 10:37:57 08/24/09 Yes. (n/m) - spicyZ 21:13:13 08/23/09 the six rubber rings under the fuel rail. ~$25 (n/m) - SuparexTT 10:44:09 08/24/09 I would check the condition of any of the turbo coolant - ZEVAN (Ca) 11:37:28 08/24/09
Post a Followup	You cannot reply to this message because you are not logged in.