Subject	Huh? It's a block of aluminum. It's holding the pressure.
Posted by	collegeboy on August 19, 2009 at 11:55 PM
	This message has been viewed 61 times.
In Reply To	740cc fuel rail options posted by WazTTed on August 19, 2009 at 09:18 PM
Message	Is it leaking from the fittings on the rails. If so, those are not tight enough, so go tighten them. Is it leaking from the injectors? Faulty installation or injectors if so. A milled block of aluminum can hold 70psi easily. The rail is not at fault here. Thanks, Mike 1991 Black 3.0 Twin Turbo La-Z-Link ^^Hard engine break in method^^ La-Z-Link ^^MY FACEBOOK...CHECK IT OUT^^ ---Me: You bought a Porsche? ---sfpearl300z: lol, no no, I have a decent sized penis so no need for that. "felt wierd fingering my exhuast for 1hr with no results :(" - zboost "lmao, i know, theres more drama and favoritism on tt.net than a middle school girls locker room" - sfpearl300z "I think I'll pass on giving my car a handjob" - joel(PA) "I did plug the holes, But I did it by taping over them a lot, I didnt think that maybe HOT air is comming through there, And it melted the tape, damnit im an ass." - DC 21
Follow Ups	740cc fuel rail options - WazTTed 21:18:53 08/19/09 Did you pressure test the rail and injectors under water - zgene4 22:45:42 08/19/09 Maybe I'm missing something but you could buy the 94+ OEM - Dave N 23:09:13 08/19/09 Why isn't it? (n/m) - Bernie (NoVA) 23:14:51 08/19/09 Huh? It's a block of aluminum. It's holding the pressure. - collegeboy 23:55:37 08/19/09 Re: Huh? It's a block of aluminum. It's holding the pressure. - WazTTed 00:04:10 08/20/09 So sorry to hear that you've been snagged by the counterfeit - Dave N 00:21:00 08/20/09 Then you shouldn't be calling it a 300degree rail. (n/m) - Bernie (NoVA) 00:22:28 08/20/09 Oh I see. Well call Coz, and get him to trade with you. (n/m) - collegeboy 00:47:41 08/20/09 Re: Re: Huh? It's a block of aluminum. It's holding the pressure. - WazTTed 01:22:31 08/20/09 Re: Re: Re: Huh? It's a block of aluminum. It's holding the pressure. - DEVILS Z-Tech (CA) 01:42:39 08/20/09 Re: Re: Re: Re: Huh? It's a block of aluminum. It's holding the pressure. - WazTTed 05:10:54 08/20/09 my aeromotive does not have the valve - spyhunterTT(nj) 05:57:58 08/20/09 Re: my aeromotive does not have the valve - WazTTed 06:46:20 08/20/09
Post a Followup	You cannot reply to this message because you are not logged in.