Subject	Re: Is that Idaho shop the one that did the work to Rays Z
Posted by	larryb on August 14, 2009 at 9:42 AM
	This message has been viewed 206 times.
In Reply To	Is that Idaho shop the one that did the work to Rays Z posted by Piranha(PHX) on August 13, 2009 at 09:59 PM
Message	They're the shop that finished the build, and did a great job, but they did not build the motor. Ray did make about 750rwhp at only 26psi. The car was running fantastic. Unfortunately, it looks like a small oversight when they where putting the new clutch in caused the spun bearing. The failure of the motor was obviously not because of a clearance issue with the bearings. If it had been so, there would have been no way the motor would have lasted 2500 miles and several 700+rwhp dyno pulls
Follow Ups	Z work in Utah - WhiteBoyFunk 10:33:31 08/13/09 tuning - sonazty 12:48:06 08/13/09 Tuning! - WhiteBoyFunk 07:09:04 08/14/09 Re: Z work in Utah - larryb 13:42:53 08/13/09 z doctor - sonazty 14:54:53 08/13/09 That is HILARIOUS! - 91TTZ(SL,UT) 17:51:30 08/13/09 Is that Idaho shop the one that did the work to Rays Z - Piranha(PHX) 21:59:27 08/13/09 Re: Is that Idaho shop the one that did the work to Rays Z - larryb 09:42:42 08/14/09 so are you talking about the six puck that was put in it or - DarkZide 01:19:28 08/15/09 Piranha? (n/m) - DarkZide 02:29:24 08/16/09 I know of a couple possibilities. - Obeeone 16:37:19 08/13/09 Re: Z work in Utah - madZdriver 17:02:24 08/13/09 Use e-mail, which people usually list on their profile. - MixManMash 17:07:05 08/13/09 I have a friend that moved to Salt Lake City. He's good - Worm Boy 02:48:14 08/14/09 Thank you to all! - WhiteBoyFunk 07:39:54 08/14/09
Post a Followup	You cannot reply to this message because you are not logged in.