TwinTurbo.NET: Nissan 300ZX forum - After nearly one year, no noises here (n/m)
Subject
After nearly one year, no noises here (n/m)
Posted by
EZEZ(TT)
on July 26, 2009 at 5:11 PM
This message has been viewed
81
times.
In Reply To
No noises yet. All the installation grease is still on the
posted by 600ZXR
on July 26, 2009 at 08:46 AM
Message
Follow Ups
ES polyurethane bushings are the best mod I've done so far.
-
600ZXR
23:50:13 07/25/09
You sure your Z is Fed and not Cal?
-
ZXRider(SoCal)
00:04:31 07/26/09
Yup, it's fed. I was thinking the same thing. Would the
-
600ZXR
00:13:56 07/26/09
The program that he installed must be based off of a Cali
-
Bernie (NoVA)
00:14:28 07/26/09
That sucks, I will have to buy a different chip now. Thanks
-
600ZXR
00:37:48 07/26/09
just put in a resistor (n/m)
-
spyhunterTT(nj)
08:07:46 07/26/09
I'm not electrically savvy so
-
600ZXR
08:58:49 07/26/09
Do you need Fed Spec, single POP? (n/m)
-
J-Mart
09:24:38 07/26/09
nice, having never done the install by itself, I always
-
LJZTT
02:50:11 07/26/09
2nd on installation without press (n/m)
-
WhiteBoyFunk
03:09:26 07/26/09
I saw a write-up...
-
en5
08:42:26 07/26/09
the tension rod needs a press for removal
-
spyhunterTT(nj)
08:14:25 07/26/09
I used two holesaws to cut the rubber out. Then a pry bar
-
600ZXR
09:24:29 07/26/09
2nd
-
gt300zxtt
12:00:06 07/26/09
Literally by hand lots of sweat and a few expletives.
-
600ZXR
08:53:42 07/26/09
Do you notice any new noises since the install? (n/m)
-
Mr.Stacy
07:08:54 07/26/09
No noises yet. All the installation grease is still on the
-
600ZXR
08:46:40 07/26/09
After nearly one year, no noises here (n/m) -
EZEZ(TT)
17:11:33 07/26/09
i have noticed new noises
-
gt300zxtt
12:11:20 07/26/09
Yeah, subframe bushings are killer to install.
-
yobobrox
09:43:45 07/26/09
Post a
Followup
You cannot reply to this message because you are not
logged in
.