Subject	Literally by hand lots of sweat and a few expletives.
Posted by	600ZXR on July 26, 2009 at 8:53 AM
	This message has been viewed 94 times.
In Reply To	nice, having never done the install by itself, I always posted by LJZTT on July 26, 2009 at 02:50 AM
Message	The only ones that were really hard were the lower shock mount bushings. I used a wide tip blunt nosed screwdriver to shoehorn it in. I found that on that bushing you have to use less force, just get it started in then push on it with the screwdriver and it will pop right in there. You do have to have a lot of hand strength to do this without all the fancy tools. "You are the biggest wanker I have witnessed today". - Bezza
Follow Ups	ES polyurethane bushings are the best mod I've done so far. - 600ZXR 23:50:13 07/25/09 You sure your Z is Fed and not Cal? - ZXRider(SoCal) 00:04:31 07/26/09 Yup, it's fed. I was thinking the same thing. Would the - 600ZXR 00:13:56 07/26/09 The program that he installed must be based off of a Cali - Bernie (NoVA) 00:14:28 07/26/09 That sucks, I will have to buy a different chip now. Thanks - 600ZXR 00:37:48 07/26/09 just put in a resistor (n/m) - spyhunterTT(nj) 08:07:46 07/26/09 I'm not electrically savvy so - 600ZXR 08:58:49 07/26/09 Do you need Fed Spec, single POP? (n/m) - J-Mart 09:24:38 07/26/09 nice, having never done the install by itself, I always - LJZTT 02:50:11 07/26/09 2nd on installation without press (n/m) - WhiteBoyFunk 03:09:26 07/26/09 I saw a write-up... - en5 08:42:26 07/26/09 the tension rod needs a press for removal - spyhunterTT(nj) 08:14:25 07/26/09 I used two holesaws to cut the rubber out. Then a pry bar - 600ZXR 09:24:29 07/26/09 2nd - gt300zxtt 12:00:06 07/26/09 Literally by hand lots of sweat and a few expletives. - 600ZXR 08:53:42 07/26/09 Do you notice any new noises since the install? (n/m) - Mr.Stacy 07:08:54 07/26/09 No noises yet. All the installation grease is still on the - 600ZXR 08:46:40 07/26/09 After nearly one year, no noises here (n/m) - EZEZ(TT) 17:11:33 07/26/09 i have noticed new noises - gt300zxtt 12:11:20 07/26/09 Yeah, subframe bushings are killer to install. - yobobrox 09:43:45 07/26/09
Post a Followup	You cannot reply to this message because you are not logged in.