Subject	No noises yet. All the installation grease is still on the
Posted by	600ZXR on July 26, 2009 at 8:46 AM
	This message has been viewed 88 times.
In Reply To	Do you notice any new noises since the install? (n/m) posted by Mr.Stacy on July 26, 2009 at 07:08 AM
Message	bushings so they are still well lubed. I got the black ones that are supposed to be graphite impregnated to avoid strange noises we will see. "You are the biggest wanker I have witnessed today". - Bezza
Follow Ups	ES polyurethane bushings are the best mod I've done so far. - 600ZXR 23:50:13 07/25/09 You sure your Z is Fed and not Cal? - ZXRider(SoCal) 00:04:31 07/26/09 Yup, it's fed. I was thinking the same thing. Would the - 600ZXR 00:13:56 07/26/09 The program that he installed must be based off of a Cali - Bernie (NoVA) 00:14:28 07/26/09 That sucks, I will have to buy a different chip now. Thanks - 600ZXR 00:37:48 07/26/09 just put in a resistor (n/m) - spyhunterTT(nj) 08:07:46 07/26/09 I'm not electrically savvy so - 600ZXR 08:58:49 07/26/09 Do you need Fed Spec, single POP? (n/m) - J-Mart 09:24:38 07/26/09 nice, having never done the install by itself, I always - LJZTT 02:50:11 07/26/09 2nd on installation without press (n/m) - WhiteBoyFunk 03:09:26 07/26/09 I saw a write-up... - en5 08:42:26 07/26/09 the tension rod needs a press for removal - spyhunterTT(nj) 08:14:25 07/26/09 I used two holesaws to cut the rubber out. Then a pry bar - 600ZXR 09:24:29 07/26/09 2nd - gt300zxtt 12:00:06 07/26/09 Literally by hand lots of sweat and a few expletives. - 600ZXR 08:53:42 07/26/09 Do you notice any new noises since the install? (n/m) - Mr.Stacy 07:08:54 07/26/09 No noises yet. All the installation grease is still on the - 600ZXR 08:46:40 07/26/09 After nearly one year, no noises here (n/m) - EZEZ(TT) 17:11:33 07/26/09 i have noticed new noises - gt300zxtt 12:11:20 07/26/09 Yeah, subframe bushings are killer to install. - yobobrox 09:43:45 07/26/09
Post a Followup	You cannot reply to this message because you are not logged in.