Subject	Well, I'm broke and trying to save time and money.
Posted by	SFnatt on July 21, 2009 at 1:26 AM
	This message has been viewed 49 times.
In Reply To	Why not just remove the tree and replace the gasket posted by Bernie (NoVA) on July 20, 2009 at 11:19 AM
Message	Somewhat contradicting to own a Z...but I didn't want to wait for the gasket or pay for it since its still fresh and it'd be nice to have the access later on. For me to check the other bearings should I put the end cap back on the rod with something soft on the crank and then crank so I can check the others? Or should I keep the rods pushed up? I'm not sure if there's enough clearance and don't want to take a chance.
Follow Ups	Finally!! After about 13 cut off wheels... - SFnatt 15:44:57 07/19/09 Re: Finally!! After about 13 cut off wheels... - DualZ (SF) 16:49:18 07/19/09 #6 bearing was goin bad - SFnatt 00:09:26 07/20/09 yeah, I remember that bracket, it gave me hell too (n/m) - ZEngineer 00:59:16 07/20/09 Why not just remove the tree and replace the gasket - Bernie (NoVA) 11:19:26 07/20/09 Well, I'm broke and trying to save time and money. - SFnatt 01:26:15 07/21/09
Post a Followup	You cannot reply to this message because you are not logged in.