Subject	Follow up:
Posted by	yobobrox on July 20, 2009 at 10:23 PM
	This message has been viewed 76 times.
In Reply To	Ah. That makes sense. Thnx (n/m) posted by yobobrox on July 20, 2009 at 09:55 AM
Message	One side worked without clamping, but the other one required a clamp to get the ball joint rod to not spin. Both torqued down without any issues other than clamping. I'm also sure that Bernie's suggestion would have worked equally well.
Follow Ups	Ball Joint for HICAS tie rod on rear... - yobobrox 20:47:29 07/19/09 blip w. impact, insert cotter pin. (n/m) - Bernie (NoVA) 21:46:15 07/19/09 Hah, I actually considered that but figured there - yobobrox 22:00:29 07/19/09 Use the force Luke, just dont break it. (n/m) - Bernie (NoVA) 22:19:40 07/19/09 Any good tips for removing/installing the ball joints? - KevinZtwin 22:47:42 07/19/09 I did a write up sometime ago when i did mine> - MikeVar82 08:39:41 07/20/09 Thanks man! I had the ball joint tool and couldn't get it... - KevinZtwin 01:01:26 07/22/09 It's held in place because of the taper. - just4kinks 00:44:58 07/20/09 Ah. That makes sense. Thnx (n/m) - yobobrox 09:55:08 07/20/09 Follow up: - yobobrox 22:23:41 07/20/09
Post a Followup	You cannot reply to this message because you are not logged in.