Subject	Spun Bearing
Posted by	Psylentrider on July 20, 2009 at 5:09 PM
	This message has been viewed 120 times.
Message	so i had a knock, replaced the bearing, the knock came back with in 20 mins. i opened the engine again today and the bearing defiantely spun, i looked at the oil passage down the rod to make sure its clear and the oil passage is about 3mm big, however it looks like it restricts to about 1mm near the upper end, is this supposed to be how it works? also if thats not the problem any help on getting it not to spin when i replace it again? i torqued it to ~32 ft-lb i dont understand what is causing it to spin
Follow Ups	Spun Bearing - Psylentrider 17:09:37 07/20/09 I'd be inspecting the oil passages in the crank, not the rod (n/m) - aliaZ 17:22:25 07/20/09 Do you have a pic of the crank? (n/m) - John@Z1 17:23:23 07/20/09 the oil passage in the crank is clear - Psylentrider 17:25:36 07/20/09 dumb question, did you turn the crank or just replace the - Dane (Houston) 22:23:29 07/20/09 Re: Spun Bearing - Psylentrider 11:11:21 07/21/09
Post a Followup	You cannot reply to this message because you are not logged in.