Subject	blip w. impact, insert cotter pin. (n/m)
Posted by	Bernie (NoVA) on July 19, 2009 at 9:46 PM
	This message has been viewed 193 times.
In Reply To	Ball Joint for HICAS tie rod on rear... posted by yobobrox on July 19, 2009 at 08:47 PM
Message
Follow Ups	Ball Joint for HICAS tie rod on rear... - yobobrox 20:47:29 07/19/09 blip w. impact, insert cotter pin. (n/m) - Bernie (NoVA) 21:46:15 07/19/09 Hah, I actually considered that but figured there - yobobrox 22:00:29 07/19/09 Use the force Luke, just dont break it. (n/m) - Bernie (NoVA) 22:19:40 07/19/09 Any good tips for removing/installing the ball joints? - KevinZtwin 22:47:42 07/19/09 I did a write up sometime ago when i did mine> - MikeVar82 08:39:41 07/20/09 Thanks man! I had the ball joint tool and couldn't get it... - KevinZtwin 01:01:26 07/22/09 It's held in place because of the taper. - just4kinks 00:44:58 07/20/09 Ah. That makes sense. Thnx (n/m) - yobobrox 09:55:08 07/20/09 Follow up: - yobobrox 22:23:41 07/20/09
Post a Followup	You cannot reply to this message because you are not logged in.