Subject	doh (n/m)
Posted by	zgene4 on July 15, 2009 at 2:43 PM
	This message has been viewed 99 times.
In Reply To	I discovered that after 15 minutes of torch & hammer work (n/m) posted by BobbyT on July 15, 2009 at 02:38 PM
Message
Follow Ups	Solid Subframe Bushings install, and - yobobrox 12:58:33 07/15/09 Correct... - BradZ (UF) 13:11:34 07/15/09 Normal - in fact most folks remove the rotors - Bernie (NoVA) 13:11:41 07/15/09 Ok - makes sense. Thanks to both of you! (n/m) - yobobrox 13:41:55 07/15/09 What a wonderful "problem" to have - BobbyT 13:53:39 07/15/09 Haha - wish I didn't have stock rotors :D - yobobrox 14:02:35 07/15/09 there's a threaded hole.just put a screw in and they pop off (n/m) - AntiHero 14:05:03 07/15/09 I discovered that after 15 minutes of torch & hammer work (n/m) - BobbyT 14:38:05 07/15/09 doh (n/m) - zgene4 14:43:22 07/15/09 holy crap (n/m) - ZiNnYc 14:53:05 07/16/09 Goodluck and I hope you own a Sawz-All :) (n/m) - Jay Shev 18:31:39 07/16/09
Post a Followup	You cannot reply to this message because you are not logged in.