Subject	Thanks Bernie. That's what I was leaning towards, but
Posted by	J-Mart on July 07, 2009 at 5:34 PM
	This message has been viewed 38 times.
In Reply To	1/8" would be my pick. 1/4" is rather thick & hard to work w (n/m) posted by Bernie (NoVA) on July 07, 2009 at 05:18 PM
Message	was somewhat worried if it would be rigid enough. Thought 1/4" would be a little on the thick side but definitely substantial. I'll go with the 1/8" sheet and brace with aluminum if needed. Jared 1994 Twin Turbo
Follow Ups	ABS Plastic for Gauge Mounting in the DIN - J-Mart 17:12:02 07/07/09 1/8" would be my pick. 1/4" is rather thick & hard to work w (n/m) - Bernie (NoVA) 17:18:34 07/07/09 Thanks Bernie. That's what I was leaning towards, but - J-Mart 17:34:09 07/07/09 As for the din, stop by your local Best Buy and ask them for - PiotrC70 22:55:57 07/07/09
Post a Followup	You cannot reply to this message because you are not logged in.