Subject	ABS Plastic for Gauge Mounting in the DIN
Posted by	J-Mart on July 07, 2009 at 5:12 PM
	This message has been viewed 74 times.
Message	I am looking at ABS from McMaster, but I don't know which thickness would be best. I am torn between 1/8 and 1/4" options, 12x12" sheet. Can someone suggest what they used? Or if there is a better finish-matched material for this? I will be installing an SBC i-D Spec R boost controller and Defi Link Display in the center DIN and then an SAFC II in the glove box. Thanks. Jared 1994 Twin Turbo
Follow Ups	ABS Plastic for Gauge Mounting in the DIN - J-Mart 17:12:02 07/07/09 1/8" would be my pick. 1/4" is rather thick & hard to work w (n/m) - Bernie (NoVA) 17:18:34 07/07/09 Thanks Bernie. That's what I was leaning towards, but - J-Mart 17:34:09 07/07/09 As for the din, stop by your local Best Buy and ask them for - PiotrC70 22:55:57 07/07/09
Post a Followup	You cannot reply to this message because you are not logged in.