Subject	Silicone & 02 sensors isn't a good mix. (n/m)
Posted by	Bernie (NoVA) on June 30, 2009 at 7:58 AM
	This message has been viewed 61 times.
In Reply To	Can anyone confirm that this is an appropriate location posted by ZEVAN (Ca) on June 29, 2009 at 08:57 PM
Message
Follow Ups	Can anyone confirm that this is an appropriate location - ZEVAN (Ca) 20:57:22 06/29/09 Looks good to me. Mine is in almost the same spot (n/m) - nissanguyz32 21:06:59 06/29/09 clock position between 9 and 3: good there - gt300zxtt 21:13:07 06/29/09 It's about 7" past the beggining of the test pipe. The - ZEVAN (Ca) 21:31:42 06/29/09 I wouldn't worry about it (n/m) - aliaZ 22:21:11 06/29/09 Worry about moving it further back or about my - ZEVAN (Ca) 23:07:35 06/29/09 moving it back won't have any significant impact on your - aliaZ 07:03:53 06/30/09 Do you mean from a time lag due to the remoteness - CaliguyPurdue (redesigning) 23:50:51 06/29/09 That's true. I just took another look at the install - ZEVAN (Ca) 00:11:05 06/30/09 I was bored so I did the maths... - CaliguyPurdue (redesigning) 01:41:36 06/30/09 I emailed you a pic of mine. SZ installed the bungs. (n/m) - RHulme 23:12:32 06/29/09 Do you mind emailing me as well? TIA (n/m) - ConVerTT 11:25:55 06/30/09 Completely wrong. It should screw into the pipe... - CaliguyPurdue (redesigning) 23:48:23 06/29/09 Hardy har har. Nice z! (n/m) - ZEVAN (Ca) 23:57:01 06/29/09 Thanks! (n/m) - CaliguyPurdue (redesigning) 14:04:16 06/30/09 Nice jackstands, Harbor Freight FTW (n/m) - WAM_Z32 01:11:00 06/30/09 Here's the best location IMHO. - Dark Diver 06:40:51 06/30/09 Silicone & 02 sensors isn't a good mix. (n/m) - Bernie (NoVA) 07:58:04 06/30/09 Unless the silicone is "Sensor Safe" (n/m) - aliaZ 08:40:19 06/30/09 It does say "sensor safe" but I will be putting some new - ZEVAN (Ca) 08:54:46 06/30/09 Thanks for everyones input. I'm going move them back to - ZEVAN (Ca) 08:59:16 06/30/09 Mine advises at least 16 or 18" behind the turbo. (n/m) - 91Z32TT 17:42:03 06/30/09
Post a Followup	You cannot reply to this message because you are not logged in.