Subject	I wouldn't worry about it (n/m)
Posted by	aliaZ on June 29, 2009 at 10:21 PM
	This message has been viewed 69 times.
In Reply To	It's about 7" past the beggining of the test pipe. The posted by ZEVAN (Ca) on June 29, 2009 at 09:31 PM
Message
Follow Ups	Can anyone confirm that this is an appropriate location - ZEVAN (Ca) 20:57:22 06/29/09 Looks good to me. Mine is in almost the same spot (n/m) - nissanguyz32 21:06:59 06/29/09 clock position between 9 and 3: good there - gt300zxtt 21:13:07 06/29/09 It's about 7" past the beggining of the test pipe. The - ZEVAN (Ca) 21:31:42 06/29/09 I wouldn't worry about it (n/m) - aliaZ 22:21:11 06/29/09 Worry about moving it further back or about my - ZEVAN (Ca) 23:07:35 06/29/09 moving it back won't have any significant impact on your - aliaZ 07:03:53 06/30/09 Do you mean from a time lag due to the remoteness - CaliguyPurdue (redesigning) 23:50:51 06/29/09 That's true. I just took another look at the install - ZEVAN (Ca) 00:11:05 06/30/09 I was bored so I did the maths... - CaliguyPurdue (redesigning) 01:41:36 06/30/09 I emailed you a pic of mine. SZ installed the bungs. (n/m) - RHulme 23:12:32 06/29/09 Do you mind emailing me as well? TIA (n/m) - ConVerTT 11:25:55 06/30/09 Completely wrong. It should screw into the pipe... - CaliguyPurdue (redesigning) 23:48:23 06/29/09 Hardy har har. Nice z! (n/m) - ZEVAN (Ca) 23:57:01 06/29/09 Thanks! (n/m) - CaliguyPurdue (redesigning) 14:04:16 06/30/09 Nice jackstands, Harbor Freight FTW (n/m) - WAM_Z32 01:11:00 06/30/09 Here's the best location IMHO. - Dark Diver 06:40:51 06/30/09 Silicone & 02 sensors isn't a good mix. (n/m) - Bernie (NoVA) 07:58:04 06/30/09 Unless the silicone is "Sensor Safe" (n/m) - aliaZ 08:40:19 06/30/09 It does say "sensor safe" but I will be putting some new - ZEVAN (Ca) 08:54:46 06/30/09 Thanks for everyones input. I'm going move them back to - ZEVAN (Ca) 08:59:16 06/30/09 Mine advises at least 16 or 18" behind the turbo. (n/m) - 91Z32TT 17:42:03 06/30/09
Post a Followup	You cannot reply to this message because you are not logged in.