| I am in the process of installing my new Viper 5901 alarm and remote start. I have done this before so i was ready, but it figures this one is more confusing. I managed all the wires except a few of the remote start wires, i need to know where to put these (if anywhere)
From the manual:
? Heavy Gauge, 10-pin connector
There are 9 heavy gauge wires coming from the large 10-pin connector. They are used to energize the ignition circuits in the vehicle. It is crucial to ensure that these connections are capable of handling the current demands. For this reason, Scotch-Locks, T-taps and other such connectors are strongly discouraged. H3/1 PINK IGNITION 1 INPUT/OUTPUT
Connect this wire to the ignition wire in the vehicle. This wire not only supplies voltage for the ignition line in the vehicle, it is also the ignition feed for the security system. H3/2 RED/WHITE (+) (30A) FUSED IGNITION 2 / FLEX RELAY INPUT 87
This wire is the polarity feed for the ignition 2/flex relay. H3/3 ORANGE ACCESSORY OUTPUT
Connect this wire to the accessory wire that powers the climate control system. H3/4 VIOLET STARTER OUTPUT
This wire hooks up to the starter side of the starter wire in the car. This wire is also pin 30 of the onboard starter kill relay. H3/5 GREEN STARTER INPUT
After cutting the starter wire connect the GREEN wire to the end going to the ignition switch. This wire is pin 87a of the onboard starter kill relay.
H3/6 RED (+) (30A) FUSED IGNITION 1 RELAY INPUT
This wire is the polarity feed for the Ignition1 relay.
H3/7 PINK/WHITE (+) IGNITION 2 FLEX RELAY OUTPUT
This wire is factory programmed as Ignition 2 and can be programmed as a
2nd accessory or as a 2nd starter.
H3/8 PINK/BLACK 87a OF IGNITION 2 FLEX RELAY
This wire is used when an ignition switch isolation on the vehicle is necessary This is common on Toyota and Nissan's which require the use of Tech Tip document
#1077. (See Menu #3, Feature #8, for programming options) H3/9 RED/BLACK (+) (30A) FUSED ACCESSORY/STARTER RELAY INPUT
This wire is the polarity feed to the accessory and starter relays.
The wires im having trouble with are all the flex relay ones, so:
H3/2
H3/6
H3/7
H3/8
Any tips on where to wire them?
Thanks
|
