I bought two Innovate LC-1 wideband controllers ages ago so that I can
log some actual street data and street tune my VerTT using Nistune.
I've decided that I want to pull the cables into the car from underneath
through the shifter boot and then route the cable to the gauges, logger,
etc.
Today, I spent about an hour being frustrated at trying to zip tip, clip,
balance etc the controllers under the car. Quite by accident I noticed
that the LC-1 was about the same size as a piece of 2" garage door track
that I had laying around. 
After a few minutes with the cutting wheel and drill ...
The track makes a decent bracket / holder and provides great debris
protection as well. I decided to hang them from the 4 bolts that attach
the transmission to the shifter. You could probably drill / tap the
framerail as an alternate location. I will be pulling the wiring behind the
shifter and up into the car (tomorrow).
And finally, the LC-1s securely in place.... 
 
|
2" Garage Door Track makes a great Innovate LC-1 bracket - 
