Subject	Since you aren't runing MAF's at all
Posted by	CaliguyPurdue (redesigning) on June 10, 2009 at 12:28 PM
	This message has been viewed 67 times.
In Reply To	Dual intake setup posted by thejoneZ (Sacto, CA) on June 10, 2009 at 12:05 PM
Message	forget the bends... just adapt the filters directly to the intake pipes. what? It looks a little stumpy, but fits great in the hand! (n/m) - ZEngineer 12/12/06
Follow Ups	Dual intake setup - thejoneZ (Sacto, CA) 12:05:24 06/10/09 what parts dont you need from that kit? - gt300zxtt 12:13:43 06/10/09 Re: what parts dont you need from that kit? - thejoneZ (Sacto, CA) 12:16:31 06/10/09 Look at the options at the bottom of the product listing (n/m) - Russell@Z1 17:07:15 06/10/09 You will probably have better luck finding the parts used. - MixManMash 12:14:49 06/10/09 Re: You will probably have better luck finding the parts used. - thejoneZ (Sacto, CA) 12:18:10 06/10/09 you will have to source those from silicone vendors - gt300zxtt 12:37:14 06/10/09 *sell (n/m) - gt300zxtt 12:40:08 06/10/09 Since you aren't runing MAF's at all - CaliguyPurdue (redesigning) 12:28:55 06/10/09 2nd. You don't need the other parts at all. - J-Mart 15:23:41 06/10/09 Re: 2nd. You don't need the other parts at all. - thejoneZ (Sacto, CA) 17:14:41 06/10/09 How about combining these... - CaliguyPurdue (redesigning) 01:59:06 06/11/09 Re: How about combining these... - thejoneZ (Sacto, CA) 14:06:47 06/11/09
Post a Followup	You cannot reply to this message because you are not logged in.