Subject	I thought about that
Posted by	jkeyser14 on May 27, 2009 at 6:55 PM
	This message has been viewed 81 times.
In Reply To	Cut slot in race with die grinder posted by Spddracer on May 26, 2009 at 06:09 AM
Message	Was too worried about damaging the spindle and then having to buy a new one. The Z is my daily driver and I couldn't take any downtime. John EngineeringHobbyist.com
Follow Ups	Front wheel bearing replacement - not your typical DIY - jkeyser14 22:08:01 05/25/09 ..or replace the entire thing from a parts car - cheaper. (n/m) - ZiNnYc 00:14:19 05/26/09 thanks, I just ordered a set last week. - spyhunterTT(nj) 06:00:57 05/26/09 Re: thanks, I just ordered a set last week. - jkeyser14 18:54:21 05/27/09 Cut slot in race with die grinder - Spddracer 06:09:07 05/26/09 2nd (n/m) - aliaZ 17:28:31 05/26/09 I thought about that - jkeyser14 18:55:32 05/27/09
Post a Followup	You cannot reply to this message because you are not logged in.